Page 1411 - Foton Workshop Manual - Tunland (AT)

ENGINE MECHANICAL - TIMING DEVICE 15-37

TIMING CHECK AND ADJUSTMENT

1 . Remove the power assembly. (Refer to "Chapter 15 Engine mechanical system
- engine assembly, replacement")
2 . Screw out the fixing bolt , take off the
overhead camshaft sprocket housing cap.

15

3 . Turn crankshaft pulley clockwise , align
the crankshaft belt mark and the Front
gear housing mark. Insert the crankshaft
timing pin into the opening with a special
tool.
4 . Align the camshaft signal mark with the
camshaft position sensor.
NOTICE

• If the alignment of crankshaft belt pulley
mark and front gear chamber cover mark
and alignment of the camshaft signal
wheel mark and the camshaft position
sensor don't occur at the same time, the
difference is 180 degree, then turn the
crankshaft pulley around again.
• If too much difference， adjust the timing:
remove the camshaft signal wheel (Refer
to "Chapter 15 Engine Mechanical - Rock
Arm Chamber Cover, Rock Arm, Rock Arm
Cushion Block, Rock Arm Bracket &
Camshaft, Camshaft overhaul "), then
install according to timing mark point to
adjust the timing.

Page 1411