Page 1468 - Foton Workshop Manual - Tunland (AT)
P. 1468

15-94         ENGINE MECHANICAL - FLYWHEEL, CYLINDER BLOCK & CRANKSHAFT

           16 .   Crankshaft bearing oil clearance check:
                NOTICE


           •      Clean crankshaft journal, crankshaft bearing and bearing cap and wipe off oil
                  on the surface.


                                                      (a)    Fit crankshaft upper bearing on cylinder block
                                                             side and place crankshaft on cylinder block.
      15
                                                      (b)    The plastic gauge arrow across the crankshaft
                                                             journal.













                                                      (c)    Fit the crankshaft main bearing and bearing
                                                             cap. Apply a thin layer of clean oil on the
                                                             screw thread of the crankshaft bearing cap
                                                             bolt and screw in the bolt by hand.
                                                      (d)    As cross order in accordance with the
                                                             diagram, tighten the crankshaft bearing cap
                                                             bolts evenly.
                                                             Bolt tightening torque:

                                                             Level 1 tightening: 50 Nm
                                                             Level 2 tightening: 80 Nm

                                                             Level 3 tightening: clockwise rotate 90
                                                             degrees

                                                           NOTICE

                                                      •      If the bolt cannot be tightened to the
                                                             specified torque, replace it.


                                                      (e)    As shown in the diagram, screw out
                                                             crankshaft bearing cap bolts evenly and take
                                                             off the crankshaft bearing cap.

                                                           NOTICE

                                                      •      The crankshaft must not be rotated during
                                                             the installation and removal of the
                                                             crankshaft bearing cap.











                                                                                                        Page 1468
   1463   1464   1465   1466   1467   1468   1469   1470   1471   1472   1473