Page 463 - Foton Workshop Manual - Tunland (AT)

DIAGNOSTICS - ENGINE CONTROL SYSTEM 04-317

(g) Use a multimeter to measure the resistance
between the pin 2, 3 of DPF temperature
sensor connector Q01 and the ground.
Standard resistance

Multimeter connection
Standard value
pin 04
Q01（2）- ground ＞10 MΩ

Q01（3）- ground ＞10 MΩ

Is the inspection result normal?
YES>To step 4.
No > Maintain or replace the harness.

4 . Replace DPF temperature sensor
(a) Replace DPF temperature sensor.
(b) Use a diagnostic apparatus to perform DTC verification procedures.
(c) Implement the steps to read sensor data stream.
(d) Check whether DTC exists.
Is the inspection result normal?

YES>Replace DPF temperature sensor
NO >To step 5.

5 . Replace ECM

(a) Replace ECM.
(b) Use a diagnostic apparatus to perform DTC verification procedures.
(c) Implement the steps to read sensor data stream.
(d) Verify that no DTC exists and the data are normal.

Page 463