Page 312 - Foton Workshop Manual - Sauvana

12B-22 ENGINE MECHANICAL - ENGINE ASSEMBLY

(c). Remove the oil pressure sensor.
NOTICE:
When removing oil pressure sensor, sealing
processing for the installed hole shall be done
well, keep the oil pressure sensor properly.
(d). Remove fixed bolt of oil filter base, take off
filter base and gasket.

14. Remove the fuel rail injector assembly
(a). Remove the fixed bolts on the oil injector
assembly of the fuel rail.
(b). Gently shake the oil rail injector, pull out oil
injector assembly.
NOTICE:
• When removing the fuel rail injector assembly,
the sealing processing for installed hole shall be
done well, keep the fuel rail injector assembly
properly.
• When removing, don't strike with the tools such
as a hammer, etc., after removing, check if the
seal ring falls off

15. Remove knock sensor
(a). Remove the fixed bolt of knock sensor,
take off knock sensor.
NOTICE:
When removing knock sensor, sealing processing
for the installed hole shall be done well, keep the
knock sensor properly.

Page 312