Page 1433 - Workshop Manual - Tunland (2017)
P. 1433
ENGINE MECHANICAL - FLYWHEEL, FLYWHEEL HOUSING, CYLINDER BLOCK & CRANKSHAFT97
15-
(a) Fit crankshaft main bearing.
CAUTION
• Check if the crankshaft main bearing is
abnormally worn and replace if necessary.
15
(b) Fit crankshaft in the vertical direction.
(c) Fit the crankshaft main bearing on the
crankshaft main bearing cap.
CAUTION
• Check if the crankshaft main bearing is
abnormally worn and replace if necessary.
(d) Install the camshaft main bearing, and tighten
the retaining bolts of the crankshaft main
bearing cap in numeric sequence.
Bolt tightening torque:
level 1 tightening: 50 Nm
Level 2 tightening: 80 Nm
Level 3 tightening: clockwise rotate 90
degrees
22 . Install the cylinder block:
