Page 1607 - Workshop Manual - Tunland (2017)

TYRE AND WHEEL - WHEEL & TYRE ASSEMBLY 33-5

ON-VEHICLE INSPECTION

1 . Check Tread Wear
(a) Measure the remaining depth of the tyre tread.
If it is below the service limit, replace it.

Limit of tyre tread remaining depth: 1.6mm
(b) Check the wear mark on the side of the tyre.
If it reaches the mark, replace the tyre.

CAUTION
Replace both left and right tyres at the same time.

2 . Check for abnormal wear in the tyre
(a) Check for wear on the tyre shoulder. If yes,
ensure the tyre pressure is correct. Rotate
the tires after adjusting the pressure.

33

(b) Check for damage in the center of the tread.
If yes, check for over-inflation. Rotate the tyres

after adjusting the pressure.

(c) Check for wear on the inner side of the tyre.

If yes, avoid turning in high speed. Check for
loose suspension parts. Check and adjust the
wheel alignment.