Page 1610 - Workshop Manual - Tunland (2017)

33-8 TYRE AND WHEEL - WHEEL & TYRE ASSEMBLY

MEASUREMENT & ADJUSTMENT

1 . Tyre Rotation

CAUTION

The arrow points at the driving direction.

(a) Figure A illustrates the tyre rotation including
the spare tyre.
(b) Figure B illustrates the tyre rotation

excluding the spare tyre.

2 . Wheel Dynamic Balance
(a) Clear the impurities in the tread and previous

balancer.
(b) Check whether the tyre pressure meets the
rated value.
(c) Select a cone according to the size of the
central rim hole, carefully install the wheel
and tighten the snap nuts.
(d) Switch on the dynamic balance analyzer.
(e) Measure the rim width.
33
(f) Measure the tyre diameter.
(g) Measure the distance between the rim edge
and the dynamic balance analyzer.
(h) Put down the wheel guard and start to
measure.
(i) After measurement, secure the balancer
subject to the unbalanced position and volume

indicated by the analyzer.
(j) Measure again and make sure the dynamic
balance value is qualified.
(k) Remove the tyre.

3 . Front Wheel Hub Adjustment (Refer to "Chapter 31. Front suspension - front
wheel alignment, adjustment")