Page 1955 - Workshop Manual - Tunland (2017)

STEERING COLUMN - COMBINATION SWITCH 51-17

(d) Install the combination switch upper cover 51
and lower cover.
(e) Tighten the cover retaining bolts.
CAUTION

Ensure the combination switch upper cover and
lower cover are installed in plce.

ftwx511049

7 . Centrally Align the Clock Spring
(a) Make sure the ignition switch is in the "LOCK" position.
(b) Make sure the positive and negative battery cables are disconnected.

CAUTION

Do not proceed with the operation within 90 seconds after the disconnection.

(c) Rotate the rotator counterclockwise by hands
until it can no longer move.
CAUTION

When installing the clock spring, the total
rotation rounds of the rotator shall be less than
6.

ftwx511053

(d) Turn the rotator for 3 rounds clockwise until
the arrow on the inner circle is aligned with
that on the upper cover. Mount the dowel pin.
CAUTION

The dowel pin shall be removed after assembly.

The new clock spring is located at the center
position by a positioning clamp. So no central
alignment is necessary.
ftwx621036

8 . Install the steering wheel. (Refer to “Chapter 51. Steering system - steering
wheel, overhaul”)
9 . Install the horn button assembly. (Refer to “Chapter 62. Supplemental restraint

system - horn button assembly, replacement”)