Page 249 - Workshop Manual - Tunland (2017)

DIAGNOSTICS - TRANSFER GEAR 04-111

Diagnostic steps

1 . Check motor

(a) Disconnect the connector.
(b) Check whether the resistance of motor is normal or not.
Check whether the result is normal?
04
Yes> go to step 2

No> Replace motor assembly.

2 . Check whether the guide wire is normal or not.

(a) Switchover the ignition switch to “OFF”.
(b) Measure the electrical resistance based on
the value in the following form.
Standard electrical resistance (check
whether there existent an open circuit)
C040
Multimeter connection Standard value

C040(1)-K001(G) ＜ 2 Ω

C040(2)-K001(B) ＜ 2 Ω

K001

ftwxd041361

Check whether the result is normal?
Yes> Replace electric timesharing 4-drive module.
No> replace connection harness