Page 260 - Workshop Manual - Tunland (2017)

04-122 DIAGNOSTICS - REVERSE RADAR SYSTEM

No > Maintenance or replace harness.

5 . Check harness and connector (reverse radar probe - ground)

(a) Ignition Switch: OFF.
(b) Disconnect reverse radar probes B006、B009.

04
(d) Measure the electrical resistance between
reverse radar probesB006（4）, B009（4）
and the ground respectively.
Standard electrical resistance (check
whether there existent an open circuit)

Multimeter connection Standard value

B006（4）、B009（4） ＜2Ω
- ground

Check whether the result is normal?
Yes> go to step 7.
No > Maintenance or replace harness.

6 . Check harness and connector (reverse radar controller-ground)
(a) Ignition Switch: OFF.
(b) Disconnect reverse radar controller C035.

(c) Measure the electrical resistance between
reverse radar controller C035（31） and the
ground.
Standard electrical resistance (check
whether there existent an open circuit)

Multimeter connection Standard value

C035（31） - ground ＜2Ω

Check whether the result is normal?
Yes>Replacement reverse Radar Controller
No > Maintenance or replace harness.