Page 447 - Workshop Manual - Tunland (2017)
P. 447

DIAGNOSTICS - AIR CONDITIONING SYSTEM                        04-309

                 Diagnostic steps

                 1 .    Check fuse

                 (a)    Disconnect battery negative cable.

                                                           (b)    Check the fuse inside the fuse box of engine
                                                                  compartment:                                       04
                                                                  •      F20(7.5A)
                                                                  •      F28(125A)

                                                           (c)    Check the fuse inside the vehicle-body fuse
                                                                  box:

                                                                  •      F17(5A)
                                                                  •      F33(5A)









                 Check whether the result is normal?

                 Yes> go to step 2
                 No> replace fuse


                 2 .    Check the starter relay
                 (a)    Disconnect battery negative cable.
                 (b)    Unplug the relay R4 of starter.

                                                           (c)    Check the relay, starter.
                                                                  Standard resistance:

                                                                                Multimeter
                                                                                                   Specified
                                                              Conditions        connection           value
                                                                                   stitch
                                                                Normal
                                                                situation            1-2           Breakover

                                                              Apply power
                                                             supply voltage
                                                               to position           3-4             <2Ω
                                                             between pin 1
                                                                 and 2,


                 Check whether the result is normal?

                 Yes> go to step 3
                 No > Replace the starter relay, and verify again whether the failure exists.


                 3 .    Check the harness and connectors (starter relay - ground)
   442   443   444   445   446   447   448   449   450   451   452