Page 731 - Workshop Manual - Tunland (2017)

DIAGNOSTICS - ENGINE CONTROL SYSTEM 04-45

(d) Connect the battery negative cable. 04
(e) Ignition switch: ON.

(f) Use a multimeter to measure the voltage
between the pin 1 of crankshaft position
sensor connector E02 and ground.
Standard voltage

Multimeter connection Standard value
pin

E02（1）- ground 4.75～5.25 V

Is the inspection result normal?

YES>To step 4.
No > Maintain or replace the harness.

4 . Check crankshaft position sensor harness

(a) Ignition switch: OFF.
(b) Disconnect the battery negative cable.
(c) Disconnect connector E02 of crankshaft position sensor.
(d) Disconnect connector E01 of ECM.

(e) Use a multimeter to measure the resistance
between the pin 2, 3 of crankshaft position
sensor connector E02 and the pin 14, 38 of
ECM connector E01 respectively.
Standard resistance

Multimeter connection
Standard value
pin
E02（2）- E01（14） ＜10 Ω

E02（3）- E01（38） ＜10 Ω