Page 777 - Workshop Manual - Tunland (2017)

DIAGNOSTICS - ENGINE CONTROL SYSTEM 04-91

(f) Use a multimeter to measure the resistance 04
between the pin 2, 3of vehicle speed sensor
connector K001 and the ground.
Standard resistance

Multimeter connection
Standard value
pin
K001（2）- ground ＞ 10 MΩ

K001（3）- ground ＞ 10 MΩ

Is the inspection result normal?
YES>To step 5.
No > Maintain or replace the harness.

5 . Replace combination instrument
(a) Replace combination instrument.
(b) Use a diagnostic apparatus to perform DTC verification procedures.
(c) Implement the steps to read sensor data stream.
(d) Check whether DTC exists.
Is the inspection result normal?

YES>Replace combination instrument.
NO >To step 6.

6 . Replace ECM

(a) Replace ECM.
(b) Use a diagnostic apparatus to perform DTC verification procedures.
(c) Implement the steps to read sensor data stream.
(d) Verify that no DTC exists and the data are normal.