Page 867 - Workshop Manual - Tunland (2017)
P. 867
DIAGNOSTICS - ENGINE CONTROL SYSTEM 04-181
(e) Use a multimeter to measure the resistance 04
between the pin 3, 4 of EGR valve connector
E18 and the pin 96, 66 of ECM connector E01
respectively.
Standard resistance
Multimeter connection
Standard value
pin
E18（3）- E01（96） ＜10 Ω
E18（4）- E01（66） ＜10 Ω
(f) Use a multimeter to measure the resistance
between the pin 3, 4 of EGR valve connector
E18 and the ground respectively.
Standard resistance
Multimeter connection
Standard value
pin
E18（3）- ground ＞ 10 MΩ
E18（4）- ground ＞ 10 MΩ
Is the inspection result normal?
YES>To step 4.
No > Maintain or replace the harness.
4 . Replace EGR valve
(a) Replace DPF pressure sensor.
(b) Use a diagnostic apparatus to perform DTC verification procedures.
(c) Implement the steps to read sensor data stream.
(d) Check whether DTC exists.
Is the inspection result normal?
YES>Replace EGR valve.
NO >To step 5.
5 . Replace ECM
(a) Replace ECM.
(b) Use a diagnostic apparatus to perform DTC verification procedures.
(c) Implement the steps to read sensor data stream.
