Page 121 - SMM2 eBOOK

Flexible sheet finishings

S.12 Generally

1. Particulars of the following shall be given:

a. Kind and quality of material. (e.g. Iinoleum, vinyl, plastic, etc.)
b. Thickness of material.
c. Method of hxing and treatment of joints.

2. Work shall be given in square metres and measured as carried out but no deduction shall
be made for voids not exceeding 0.50 m2.

3. Laps and seams shall be given in the description stating the extent of lap and the type of
seam.

S.13 Wall and ceiling finishes

1. Work to walls and ceilings shall be given separately in accordances with clause S.3.

2. Cover strips over joints of finishings shall be described and given in metres stating the
size. Ends, angles and intersections shall be deemed to be included with the items.

S.14 Floor finishings

Work to fioors shall be given in accordance with clause S 6.

S.15 Labours

Labours on finishings shall be given in accordance with clause S.1.8.

Dry linings and partitions

S.16 Generally

1. Particulars of the followings shall be given:

a. Kind and quality of sheeting.
b. Thickness of sheeting.
c. Size and spacing of supports (including details of design module both for the
building and the work in this section).
d. Treatment of joints. Lapped joints shall be given in the description and no
allowances shall be made for these in measurement.
e. Nature of structure to which members are to be fixed and methods of fixing. Where
to steel framing, the size and spacing of the members of such framing shall be
given. Where hxing is obstructed by services it shall be so stated.
f. Any services which are integrated with the lining including additional members, etc.
g. Layout of joints. (If none stated, the layout shall be at the contractor's discretion).

2. Linings shall be given in square metres and shall include all necessary members and
accessofies except those required to be measured separately under clause S.16.3. No
deduction shall be made for voids not exceeding 0.5.m2.

118