Page 191 - The Ashley Book of Knots
P. 191
THE ASHLEY BOOK OF KNOTS
996. A PENTAGON with very precise edges. Tie over an enlarged
diagram and tuck each end to the stem beyond the second standing
part. This requires a craftier hand than was needed for the three-
or four-sided knots, but if worked with care it should present no
difficulties.
997. A similar but larger design provides a PENTAGON with a series
of ten bights around the rim. In this knot, as in the last, each end
should finally be tucked to the stem beyond a second standing part.
998. A SEVEN-BIGHT KNOT with a five-part center. Surprisingly
enough, despite this disparity of rim and center, the knot is the
most successful large DISK shown. Probably this irregularity con-
tributes something to the success of the knot, for jlji994, which is
just as large and quite as round, has such a regular weave that it
detracts from the impression of roundness and suggests an angular
figure.
999. A ROUND FLAT KNOT that in form is a very short, truncated
cone. Tuck the ends of the knot beyond the second standing part.
This is clearly illustrated in the diagram.
1000. The remaining knots may be termed SPORTS, since they do
not conform to the arbitrary limitations to which the knot:' already
shown in this ;::h;:lpter have ger'lprally been held. The present knot has
no compartment at all in the top center; instead, it has a cross. The
form is based on SINGLE-STRAND BUTTON KNOT jlji6I9, but it is tied
with two strands Instead of a single strand. The strands are seized
and introduced through the hole in the board or table. If the knot
is to remain single after completing the diagram form, lead one end
over the center diagonal befere sticking it down. If doubled, the knot
perhaps is more satisfactory.
Other ON£-STRAND BUTTON KNOTS may be tied as TWO-STRAND
BUTTONS by pulling down the center part, which automatically pro-
vides a four-part stem. Still others may be easily tied as FOUR-STRAND
BUTTONS. Most of the TRIANGULAR SINGLE-STRAND BUTTONS of Chap-
ter 5 were originally adapted from multi-strand diagrams that were
•
already included in this chapter.
1001. This shows a very regular knob pattern that may not be
completely tied by introducing the strands either at the rim or at the
center, because one line of the diagram fails to touch either the rim
or the center.
To tie: Copy the right diagram, take a SiX-STRAND SINNET, and
stick two opposite ends up throu~h holes on the diagram at the spot!
, 000
[ 182 ]