Page 50 - Mercury Repower Guide
P. 50

ACCESSORY KITS FOR PLUS-SERIES ENGINES


                                       ACCESSORY KITS FOR PLUS-SERIES ENGINES



             ENGINE COVERS                                       CARBURETOR WEDGE KIT

             ENGINE COVER - BLUE FLAME                           CARBURETOR WEDGE KIT












                  8M0079198                                           879288T62
             This engine cover features a custom hand air‑brushed blue flame design.  Being a  Helps eliminate carburetor lean out condition in extremely hard right turns.
             custom part there will be some visible differences from one part to the next.  It is  Fits MCM 3.0L engines (1998‑2016)
             the same as used on some Plus Series engines.
             Fits non‑ECT 4.3 MPI, 5.0 MPI, 350 MAG, & 377 MAG MerCruiser engines built
             between 2001‑2015.  It also fits all 4.3L, 350, 357, and 383 Plus Series engines.  CRANKSHAFT SPACER
             ENGINE COVER - RED FLAME
                                                                 SPACER                                               MERCRUISER












                  8M0103982
             This engine cover features a custom hand air‑brushed red flame design.  Being a  23-8M0088395
             custom part there will be some visible differences from one part to the next.  It is  For use when servicing with a new harmonic balancer on Gen+ V6 & V8 engines
             the same as used on some Plus Series engines.       that are not equipped with a Crankshaft Position Sensor (CPS).  New harmonic
                                                                 balancers p/n 863397 are all machined with a shorter snout to accommodate a
             Fits non‑ECT 4.3 MPI, 5.0 MPI, 350 MAG, & 377 MAG MerCruiser engines built  reluctor wheel used with a CPS.  This spacer fits onto the crankshaft before the
             between 2001‑2015.  It also fits all 4.3L, 350, 357, and 383 Plus Series engines.  installation of a new harmonic balancer to fill the region normally occupied by a
                                                                 reluctor wheel.  This prevents disassembly of a non‑CPS engine to install a reluctor
             FLAME ARRESTOR                                      wheel when servicing with a new harmonic balancer.
             FLAME ARRESTOR - 3 IN. ELEMENT                      BLOCK PLUGS - DIPSTICK HOLE
                                                                 BLOCK PLUG











                  8M0119614
             An alternate flame arrester for use with the 540 MAG Bravo 4V.  This flame
             arrestor lower the overall engine height by 1" to allow engine hatch clearance for  19-807861
             some applications.                                  Dipstick tube hole plug. This plug has a 9.367 mm (.3688 in.) OD with a hex
                                                                 shaped head.
                                                                 All MCM V6 long blocks that have the oil dipstick tube going to the oil pan drain on
                                                                 the port side have the dipstick tube hole in the cylinder block plugged with  this plug







             2019 Repower Product Guide                                                                       37
   45   46   47   48   49   50   51   52   53   54   55