Page 7 - FQ10481.CorvalGroup.MN - AlabamaFoodProcessor.DC10000S - 4000 Gal Tank

Page No. 6
Proposal No. Q10481
Date: April 11, 2017
Note II - Certified Inspection

All Ludell Direct Contact Water Heaters are factory inspected.

Note III - Customer to Provide

A. Constant minimum gas pressure to the entrance of the gas train of:
5 PSIG @10,000 FT /HR.
3

B. Constant water pressure to the entrance of the water heater of:
30 PSIG minimum at 225 GPM

B.1 Ludell can furnish a booster pump with necessary controls at
added cost, if required to obtain 30 PSIG minimum constant water
pressure.

C. Disconnect switches and reattachment of electrical wiring and piping
subassemblies. Note: The heating system is completely prewired and
prepiped, however it must be disassembled in subassemblies to prevent
damage in shipment.

D. Electrical/Mechanical utility service to the heater.

D.1 Power *230/460 Volts, 3 Phase, 60 Hertz to blower and pumps.
*To be verified by customer.
D.2 Control 115 Volts, 1 Phase, 60 Hertz to heater and burner control
panel.

E. Piping from the heater overflow to a drain.

F. Installation and hook-up of equipment prior to visit from Ludell Field
Engineer.

G. Local permits and approvals, if applicable.

Note IV - Optional Offer (Available Upon Request)

A. Ludell offers dual gas trains for use with either propane or natural gas.
In addition, various types of gas trains are available, which meet GE GAP
(formerly IRI), AGA, and FM specifications.

B. Spare parts kit.

C. Extra stack sections.

D. Low NOX emissions system, if 80 ppm NOX is not sufficient.

E. T-316L stainless steel construction, if cold water supply has greater than
50 ppm of chlorides.