Page 113 - Corkjoint E-Catalogue

MIXING PROCEDURES

GUN GRADE
Supplied in a ready to mix container, with all the components packed in a single tin. The material shall be
mixed thoroughly with a slow speed drill (300-400 rpm) fitted with a flat bladed paddle for 2-3 minutes till a
uniform colour and consistency is achieved.
Note : Mix one full kit at a time to avoid improper mix ratio. DO NOT PART MIX.

POURING GRADE
Supplied in a pre-weighed two parts pack which requires on site mixing. Pour the hardener (Part B) into the
base (Part A) pail and mix thoroughly with a slow speed drill (300-400 rpm) fitted to a flat bladed paddle for 1-2
minutes till a uniform colour and consistency is achieved.
Note : Mix one full kit at a time to avoid improper mix ratio. DO NOT PART MIX.

FINISHING
Once the sealant has been applied, a suitable rounded tool soaked in soapy water can be used to achieve a
smooth finish. Any masking tape applied should be removed before the sealant skins over.

CLEANING
Remove all excess sealant with a scraper. Any spillage can be cleaned using a solvent like Xylol. Clean all tools
and sealant gun using a similar solvent immediately after the tooling is finished.

TYPICAL APPLICATIONS

Bond Breaking Tape Polyseal PS

Expansion Joint Fillerboard

1st Pour 2nd Pour
Lean Concrete

HORIZONTAL FLOOR JOINT APPLICATION

Polyseal PS
Backer Rod

Expansion Joint Fillerboard

1st Pour Backer Rod Polyseal PS 2nd Pour

VERTICAL WALL JOINT APPLICATION

STORAGE & SHELF LIFE

Store in a cool, dry place and keep away from all sources of heat and sunlight. In tropical climates, store in air
condition rooms. The shelf life is up to 12 months in un-opened condition and if stored as per
recommendations. Excessive exposure to sunlight, humidity and UV will result in the deterioration of the
quality of the product and reduce its shelf life.

info@corkjoint.com | corkjoint.com Page 4