Page 22 - Scanreco - Instruction Manual: G5 rocket flex/pocket system

22/33

7 Radio information

The G5 system family incorporates an automated frequency jumping technology,
a reliable radio transmission highly resistant to interference.

The radio transmission takes place within the ISM-band used at pre-defined channels.
The channel switches takes place multiple times per second following a pseudorandom
sequence order which ensures the operator that transmission takes place at an optimal
frequency at all times!

No transmitter uses the same pseudorandom sequence order when switching
channels; this minimizes the risk of two G5 systems interfering with each other.
The G5 system is approved to transmit on the ISM band. The radio is license free
for the end user.

Attribute Information
Frequency 2,400 - 2,4835 GHz
Channels FHSS, DSSS, THSS
management
Channel order Pseudorandom
Channel capacity Duplex
System address/ID 16777216 unique system addresses available
Redundancy CRC-16
Range > 100 meters > ~ 330 feet

FCC information
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation. This equipment has been tested and found to comply with the limits for a Class. A digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates,uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own
expense.
Warning
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Industry Canada Information
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage
est susceptible d’en compromettre le fonctionnement.
CAN ICES-3 (A)/NMB-3(A)

The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must
not be co-located or operating in conjunction with any other antenna or transmitter.

When the device is stored on the operators belt it must be shut off. Pressing the buttons and operating the machine while the device is
hanging from the belt or any other place it not allowed. It must be held in the hand.
L’antenne (s) utiliseé pour cet émetteur doit être installé pour fournir une distance de séparation d’au moins 20 cm de toute personne
et ne doit pas être co-localisées ou opérant en conjonction avec une autre antenne ou émetteur.
Lorsque l’appareil est stocké sur la bande des opérateurs, il doit être arrêté. Appuyant sur les boutons et faire fonctionner la machine
alors que l’appareil est accroché à la ceinture ou tout autre lieu il pas permis. Il doit être tenu à la main.