Page 80 - Wago_ThePluggableConnectionSystem_Volume5_2015_US.pdf
P. 80
®
3 WINSTA MIDI, 770 Series
Handling:
78
Preparation Termination via CAGE CLAMP S
®
We recommend pulling the pre-latched strain relief housing over 1. Strip length, outer insulation = x mm 1 To terminate fine-stranded conductors, open clamping unit via
the cable prior to termination. However, the strain relief can be 2. Strip length: = 9 mm 2.5 mm screwdriver and insert stripped conductor until it hits
mounted at a later time as well. 3. Extended ground conductor = 8 mm backstop.
Termination via CAGE CLAMP S
®
Insert stripped solid conductor until it hits backstop. To terminate fine-stranded conductors, open clamping unit via To remove the conductor, actuate the clamp via 2.5 mm screw-
2.5 mm screwdriver and insert stripped conductor until it hits driver and pull out the conductor.
backstop.
Strain relief installation
Latch the strain relief housing on the plug/socket. Note the Prepare strain relief housing by snapping together upper and Tighten strain relief screw using a 2.5 mm screwdriver.
“TOP” inscription. bottom part.
Variable coding Marking
Simply cut off the coding pin from the socket. Insert coding pin into plug (break first) until it engages. Marking strain relief housing via WSB quick marking system.
1 Strip length, outer insulation: 2-pole = 35 mm, 3- to 5-pole = 55 mm
