Page 500 - Wago_PCB_TerminalBlocksConnectors_Volume2_2015_US

Male Headers with Solder Pins
7 Pin Spacing: 7.62 mm
498 MCS MAXI
● Male headers may be mounted horizontally or vertically via straight or
angled solder pins
● 3 solder pins per pole for mechanically and
electrically sturdy connection to PCB

● 100% protected against mismating
● Coding via strips

Technical data:

Pin Spacing 7.62 mm Derating Curve
0.3 in.
Ratings per IEC/EN 60664-1 831-3102 female connector with 831-3622 male header
Pin spacing: 7.62 mm / Conductor size: 6 mm “f-st”
2
Overvoltage category III III II Based on: EN 60512-5-2 / Reduction factor: 0.8
Pollution degree 3 2 2 Current in A
Rated voltage 500 V 630 V 1000 V 45
Rated surge voltage 6 kV 6 kV 6 kV 40
Nominal current 41 A 41 A 41 A 35
Approvals per UL/CSA 30
Use group UL 1059 B C D
Rated voltage – 300 V 600 V 25
Nominal current UL – 42 A 5 A 20
Nominal current CSA – 50 A 5 A 15
10
Solder pin data: 5
Solder pin: length/width 4 mm / 1 x 1.2 mm 0 10 20 30 40 50 60 70 80 90 100105
Solder pin: drilled hole diameter 1.7 +0.1 mm Ambient operating temperature in °C
2-, 4-, 6-, 8-pole Conductor rated current

Material data: MCS MAXI accessory: Page:
Material group I
Insulating material Polyamide 6.6 (PA 6.6) Coding strips 499
Flammability rating per UL 94 0V
Lower/Upper limit temperature -60 °C / +105 °C
Contact material Electrolytic copper (E )
Cu
Contact plating tin-plated
MCS — MULTI CONNECTION SYSTEM includes connectors without breaking capacity in accordance with
DIN EN 61984.
When used as intended, these connectors shall not be connected/disconnected when live or under load. The circuit
design should ensure header pins, which can be touched, are not live when unmated.

Additional approvals and corresponding ratings can be found at www.wago.com. For additional technical information, see Section 13.