Page 502 - Wago_PCB_TerminalBlocksConnectors_Volume2_2015_US

Male Connectors
7 Pin Spacing: 7.62 mm
500 MCS MAXI
● Universal connection for all conductor types

● Inserting solid and ferruled conductors via push-in termination – no
operating tool needed.

● Integrated test ports for 2 mm Ø test plugs

● 600 V UL acc. to UL 1059
● 100% protected against mismating

● With coding pins

Technical data:

Pin Spacing 7.62 mm Derating Curve
0.3 in.
Ratings per IEC/EN 60664-1 831-3102 female connector with 831-3202 male header
Pin spacing: 7.62 mm / Conductor size: 10 mm “f-st”
2
Overvoltage category III III II Based on: EN 60512-5-2 / Reduction factor: 0.8
Pollution degree 3 2 2 Current in A
Rated voltage 800 V 1000 V 1000 V 90
Rated surge voltage 8 kV 8 kV 8 kV 80
Nominal current 41 A 41 A 41 A 70
Approvals per UL/CSA 60
Use group UL 1059 B C D
Rated voltage – 600 V – 50
Nominal current UL – 42 A – 40
Nominal current CSA – 50 A – 30
20
Conductor data: 10
Connection technology CAGE CLAMP S 0 10 20 30 40 50 60 70 80 90 100105
®
Conductor size: solid 0.5–10 mm 2 Ambient operating temperature in °C
Conductor size: fine-stranded 0.5–10 mm 2 2-, 4-, 6-, 8-pole Conductor rated current
Conductor size: fine-stranded 0.5–6.0 mm 2 (with insulated ferrule)
Conductor size: fine-stranded 0.5–6.0 mm 2 (with uninsulated ferrule)
AWG 20–8
Strip length 13–15 mm / 0.52–0.58 in.

Material data: MCS MAXI accessories: Pages:
Material group I
Insulating material Polyamide 6.6 (PA 6.6) Marking accessories 570 – 573
Flammability rating per UL 94 0V Operating tools 556 – 558
Lower/Upper limit temperature -60 °C / +105 °C Direct marking 501
Clamping spring material Chrome nickel spring steel (CrNi) Test plug, 2 mm Ø 568
Contact material Electrolytic copper (E ) DIN 35 rail 576
Cu
Contact plating tin-plated Strain relief plates 502
MCS — MULTI CONNECTION SYSTEM includes connectors without breaking capacity in accordance with
DIN EN 61984.
When used as intended, these connectors shall not be connected/disconnected when live or under load. The circuit
design should ensure header pins, which can be touched, are not live when unmated.

Additional approvals and corresponding ratings can be found at www.wago.com. For additional technical information, see Section 13.