Page 2 - Joyce - Stainless steel screw jacks

STAiNLESS STEEL JACKS ORDERiNg iNFORmATiON

Instructions: Select a model number from this chart.
2-Ton 2-Ton Reverse Base 5-Ton 10-Ton 15-Ton 20-Ton 25-Ton
SwJ62 RSwJ62 SwJ65 SwJ810 SwJ815 SwJ820 SwJ1125
SwJ122 RSwJ122 SwJ125 SwJ2410 SwJ2415 SwJ2420 SwJ3225
SwJ242 RSwJ242 SwJ245
DSwJ62* DRSwJ62* DSwJ65* DSwJ810* DSwJ815* DSwJ820* DSwJ1125*
DSwJ122* DRSwJ122* DSwJ125* DSwJ2410* DSwJ2415* DSwJ2420* DSwJ3225*
DSwJ242* DRSwJ242* DSwJ245*
Important Note: *Not self-locking, may lower under load. Brake motors or external locking systems are recommended.
D: Double Lead Screw.
R: Reverse Base Jack (only available on 2-ton jacks).
(For 25:1 ratio, contact Joyce/Dayton.)

Sample part Number: RSwJ62u2S-6.00-STDX-STDX-B

Jack Configuration

Left Side Right Side Additional
Shaft Code Shaft Code Options
U=Upright I=Inverted
(see below) (see below) X=Standard Jack,
no additional options
End Conditions
S=Additional
Specification Required
(comment as necessary)
1=T1
(plain end) Anti-Backlash p. 180
A=Split Nut
A90=A90 Design
A95=A95 Design
2=T2 XXXX=Remove XXXX=Remove Protective Boots
(load pad) STDX=Standard STDX=Standard pp. 170-172
B=Protective Boot
D=Dual Protective Boot
For optional shaft codes, For optional shaft codes,
see page 61. see page 61.
Finishes p. 179
3=T3 F2=Epoxy Paint
(threaded end) Stainless Steel Screw Jack Rise F3=Outdoor Paint
Process
Rise is travel expressed in inches and not the actual screw length.
Motor Options
M1=Less Motor
4=T4 M2=Brake Motor
(male clevis) M3=Single Phase
Motor (120VAC)
M4=50Hz Motor
Grease/Seals
H1=High Temperature
Jack Designs Operation
H2=Food Grade
Screw Stops
ST0=Extending
ST1=Retracting
ST2=Both
• Specify as many
S=Translating K=Keyed for Non N=Traveling Nut D=Double Clevis* A=KFTN Trunnion*
Rotation T=Trunnion* options as needed
*Contact Joyce/Dayton with your requirements.

60 joycedayton.com Custom products are available • Contact Joyce/Dayton with your requirements 800-523-5204
sales@joycedayton.com