Page 69 - Wago_Rail-MountedTerminalBlockSystems_Volume1_2015_US.pdf

1
S

67
Both 2006-8671 and 2006-8661 TOPJOB S disconnect
®
terminal blocks have been specially designed for use in
photovoltaic and wind power systems, where voltages 1
exceeding 1,000 V (IEC) and 600 V (UL) are required
(e.g., generator junction boxes).
· Ideal for high voltages in renewable energy
applications
· Disconnect terminal blocks with two alternative
disconnect options:
with orange knife disconnect (2006-8671)
with orange disconnect plug (2006-8661)
· This 2006 Series terminal blocks are approved for
30 A/1,500 VDC (IEC) or 1,000 VDC (UL) 1 Conductor sizes: 0.5 mm² – 10 mm² “s + f-st”;
· With a terminal block width of 15 mm, the maximum Push-in conductor sizes: 1 mm² – 10 mm² “s”
cross-section for solid and fine-stranded conductors is and 1.5 mm² – 6 mm²
Disconnect/test terminal block with knife disconnect 10 mm² (AWG 8) and 6 mm² (AWG 10) for ferruled “insulated ferrule, 12 mm”
(2006-8671) in disconnect position conductors. 2 AC/DC 1000 V = rated voltage
· Equipped with test slots DC 1500 V
· Compatible with through terminal blocks of the same 12 kV = rated surge voltage
profile and all other TOPJOB S terminal blocks 3 = pollution degree
®
(see Section 14)
3 Strip length, see packaging or instructions.
4 Protective warning marker must be applied individual-
ly.

Carrier terminal block (2006-8661) with receptacle for Orange disconnect plug (2006-8401) in operating posi- Orange disconnect plug (2006-8401) in parked position
orange disconnect plug tion

Commoning a 15 mm wide terminal block via push-in type Cover seals unused conductor entry.
jumper bars: 1 to 3 (2006-433) and 1 to 5 (2006-435).

Test slots on both terminal block sides allow for direct mea- Alternatively, measurement can also be performed using
®
surement. TOPJOB S connectors (2006-511) from terminal block 1
to 2. Spacer modules (2006-549) must be used to com-
pensate for the 15 mm terminal block width.