Page 12 - CSI Product Catalogue

Bio-Foam

Casting Materials A unique system for the taking of a three dimensional
cast of shoeprints. Each BIO-FOAM impression kit comes
in a cardboard container which is suitable for storage
and will protect the impression.
Directions for use are simple. Press the footwear into the
BIO-FOAM and remove the shoe. Spray the impressions
with a separating agent i.e. hair spray. You now have an
impression that can be cast in the normal way.
CODE
95263

Crownstone Plaster

The importance of a good footwear or tyre tread cast is
invaluable. Crownstone Plaster gives excellent definition and
good colour contrast.
Remember the prepared and mixed casting material must
not be poured directly over all areas of the impression, but
directed to one side only. Depending upon environmental
conditions the actual setting times vary from 20 minutes to
about 1hour 45 minutes. SIZE CODE
Using warm water can improve setting times. 1kg 95210
5kg 95211
25kg 95212

Denstone Plaster

The importance of a good footwear or tyre tread cast is
invaluable. Denstone Plaster gives good definition and good
colour contrast.
As with the Crownstone Plaster the prepared and mixed casting
material must not be poured directly over all areas of the
impression, but directed to one side only. Depending upon
environmental conditions again the actual setting times vary SIZE CODE
from 20 minutes to about 1hour 45 minutes although Denstone 1kg 95215
usually sets a little quicker than Crownstone Plaster.
5kg 95216
Using warm water can improve setting times. 25kg 95217

www.csiequipment.com
Page 9