Page 485 - Icon Ridge Industrial Tools Catalog

Lathe tools \ Technical introduction–turning - ISO turning

Negative
RH – The robust one with soft cut! UR – The robust one with soft cut!
Use Robust chip breaker with a wide infeed range for unfavourable Soft-cutting roughing geometry with smooth cut
cutting conditionsƒ in stainless steel
Advantages ƒ Very soft cut for deep cutting depths with good surface quality ƒ Optimised contact surfaces ensure good heat dissipation
ƒ For deep cutting depths and high feeds yet achieving very soft ƒ Special chip breakers with coolant pockets keep the coolant
chip deformation on the cutting edge for a long time
ƒ Optimised contact surfaces ensure good heat dissipation
Stability
Cutting forces
Surface quality
16,0
8,0
RH 4,0 UR
2,0
1,0
0,5
0,1 0,2 0,4 0,8 1,6
Positive
FP – extremely positive cutting opti- MP – positive cutting and yet robust! MU – soft cut with unstable conditions!
mised for smoothing and fine lathing!
Use Very positive chip breaker for low cutting Positive chip breaker for medium infeeds Positive chip breaker for medium infeeds
depths and high surface qualities with high cutting edge stability with soft cut
Advantages ƒ Very low cutting forces and good chip ƒ Low cutting forces and high cutting edge ƒ Wide range of applications in unstable
control stability in unfavourable conditions conditions
ƒ Wide chip breakage scope for smoothing ƒ High feed rates and high material ƒ High feed and low cutting forces
and precision lathe machining removal rate
ƒ Wide material range ƒ Variable infeed area with controlled chip
breakage
Stability
Cutting forces
Surface quality
16,0 16,0
8,0 8,0
FP MP MU
4,0 4,0
2,0 2,0
1,0 1,0
0,5 0,5
12° 10°
0,1 0,2 0,4 0,8 1,6 0,1 0,2 0,4 0,8 1,6

Source: Hahn+Kolb Werkzeuge GmbH
Technical data subject to change. www.iconridge.com 485
Availability subject to country specific rules and regulations.