Page 487 - Industrial Tools Catalog (1)
P. 487
Lathe tools \ Technical introduction–turning - ISO turning
Application
Substrate K15 K15
Grain size 1 µm 1 µm
Type of coating PVD, TiALN-TIN
Coating thickness 6 µm
Operating conditions Good-unfavourable Good-unfavourable
cutting speed
Hardness
Toughness
Insert MN5 – positive cutting optimised for non-ferrous metalworking!
Advantages Positive chip breaker optimised for wide infeed range and high surface qualities
Low cutting forces and good chip breakage
Wide clamping range for smoothing and moderate machining
Optimised geometry for long-chipping non-ferrous metals and smoothing of stainless steel
Stability
Cutting forces
Surface quality
N
16
a ( mm ) p 6,3 10 MN5
4 MN5
2,5
1,6
1
0,63
0,4
0,25
19°
0,16
0,1
0,025 0,04 0,063 0,1 0,16 0,25 0,4 0,63 1 1,6 2,5
f ( mm )
Cemented carbide grades ISO N
Positive ground and polished ISO N type for non-ferrous metals!
Advantages:
Proven basic substrate
Positive cutting geometry
Highly form-fitting coating
Polished chip surfaces
Excellent value for money
range of applications
application coating
01 05 10 15 20 25 30 35 40 45
ISO CVD OHW6310
N
OHC6310
OHW6310 OHC6310
Application The high-performance one in non-ferrous metals! The high-performance one with form-fitting coating!
High-performance variety for machining in non-ferrous metals with High-performance variety for finishing in stainless steel, special alloys
high hardness and wear resistance and low tendency to stick for and non-ferrous metalworking with high hardness and wear resistance
use in good to unfavourable operating conditions. and low tendency to stick for use in good to unfavourable operating
conditions.
Application
Substrate K15 K15
Grain size 1 µm 1 µm
Type of coating PVD, TiCN
Coating thickness 6 µm
Operating conditions Good-unfavourable Good-unfavourable
cutting speed
Hardness
Toughness
Insert MN4-
Positive cutting optimised for non-ferrous metalworking!
Advantages Positive chip breaker optimised for wide infeed range and high surface qualities
Low cutting forces and good chip breakage
Wide clamping range for smoothing and moderate machining
Optimised geometry for long-chipping non-ferrous metals and smoothing of stainless steel
Stability
Cutting forces
Surface quality
Source: Hahn+Kolb Werkzeuge GmbH
Technical data subject to change. www.iconridge.com 487
Availability subject to country specific rules and regulations.
