Page 23 - GuardII+ Series 4208 Platform SM User Manual

Installation

5.5. Enclosure Cable Entry

Before installing the SM card, a new cable entry hole may need to be drilled into the
GuardII+ enclosure for the SM sensor cables. If the conduit is already run to the monitor, then
skip to Section 5.6. If new holes are required, refer to the GuardII+ Platform User Manual for
instructions on drilling these holes.

5.6. SM Card Installation

If the GuardII+ was purchased with the SM card installed, skip to Section 5.7.

5.6.1. Existing Flux or EV Card
In some cases, the GuardII+ may have an existing Flux or endwinding vibration card (EV),
and the monitor is being upgraded to include SM. In this case, the existing connections to the
card need to be disconnected before removing the card.

Note:
Be sure to record the current connections before disconnecting them, so
they can be restored after installing the new card.

Disconnect any existing connections, and then loosen the thumbscrews holding the card
in place. Slide the card towards the bottom of the enclosure until it disconnects and can be
removed; this is no longer required.

Figure 5-2 Remove Existing Flux/EV Card

17
www.irispower.com