Page 17 - Terrova Freshwater Trolling Motor Owner's Manual
P. 17

CONNECTING A UNIVERSAL SONAR EXTENSION CABLE








         2      c.  When installing with a Solix, the Built-In MEGA   Humminbird Solix Fish Finder
                    Down Imaging cable can be plugged directly into
                    the Solix fish finder. Plug the Built-in MEGA Down
                    Imaging cable into the corresponding connection on
                    the Solix fish finder.
                                                                  Fourteen Pin Connector
                d.  When installing with a Helix, first attach the Adapter                       Solix Fish Finder
                    Cable and then plug the Adapter Cable into the           Locking Collar        Connection
                    Helix fish finder. The Adapter Cable will only have
                    one connection that is keyed on the back of the                             Plug directly into
                    Helix fish finder. Plug the Adapter Cable into the                          Solix Fish Finder
                    only matching keyed connection.
                                                                      Built-In MEGA Down Imaging
                   NOTICE: Check for compatibility or any required        from Trolling Motor
                   adapter cables online at minnkotamotors.com. The
                   cable from the trolling motor can be extended with a   Humminbird Helix Fish Finder
                   10’ Extension Cable #720081-1 or the 30’ Extension
                   Cable #720081-2 found at humminbird.com.


                   NOTICE: If any cables need to be routed, please   Fourteen Pin Connector
                   follow the guidelines in the Routing Connection                   Adapter Cable
                                                                                                        Adapter
                   Cables section of these installation instructions.  Locking Collar  (Helix ONLY)   Cable Keyed
                                                                                                       Connection





                                           Keyed Adapter Cable
                                           for Helix Fish Finder   Built-In MEGA                             Plug into
                                                                 Down Imaging from                          Helix Fish
                                                                                                              Finder
                                                                   Trolling Motor
                NOTICE: The connectors are keyed to prevent
                reversed installation.




         Universal Sonar

         Your trolling motor may be pre-installed with a Universal Sonar transducer system. Universal Sonar is a 2D sonar transducer with a
         temperature sensor that is integrated into the lower unit of the trolling motor.  It has an operating frequency of 83/200 kHz. Connecting
         this transducer to a compatible fish finder gives you a 2D sonar view of what is happening directly below your trolling motor. The
         integrated design protects the transducer from underwater hazards, and prevents tangles and damage to the transducer cables.
         All Universal Sonar motors are equipped with an internal bonding wire, incorrect rigging will cause sonar interference and can damage
         your trolling motor, electronics and other boat accessories. To minimize trolling motor interference, ensure that the fish finder and trolling
         motor are powered by separate batteries. Please refer to the Battery & Wiring Installation and Motor Wiring Diagram sections of this
         manual for correct rigging instructions.




       ©2018 Johnson Outdoors Marine Electronics, Inc.                                                 minnkotamotors.com  |  17
   12   13   14   15   16   17   18   19   20   21   22