Page 18 - Terrova Freshwater Trolling Motor Owner's Manual
P. 18

CONNECTING A UNIVERSAL SONAR EXTENSION CABLE







         The Universal Sonar Cables are shielded to minimize interference. To protect this shielding the cables should not be pulled tight against
         sharp angles or hard objects. If using cable ties, do not over-tighten.  Any excess cable should be bundled in a loose loop of no less than
         4” in diameter. In certain situations, air bubbles may adhere to the surface of the Universal Sonar transducer, and effect the performance.
         If this happens simply wipe the surface of the transducer with your finger.


             NOTICE: Universal Sonar does not support imaging screens that require higher frequencies such as 455 kHz or 800 kHz (Down
             Imaging, Side Imaging, etc.).  Down Imaging (DI) specific units are not compatible with Universal Sonar.  See compatibility chart
             for a list of compatible fish finders at minnkotamotors.com.

         The connector for Universal Sonar exits the trolling motor below the Control Head and consists of a 4 pin plug. An adapter cable (MKR-
         US2) that is sold separately is required for all installations. For a current list of compatible fish finders and the correct adapter cable, or
         more information on Universal Sonar, please visit minnkotamotors.com.

         1      a.   Place the motor in the deployed position.
                                                                                      Control Head
                b.  Locate the Universal Sonar, if equipped, at the base
                    of the Mount.
                                                                                   Universal
                c.  Locate the Universal Sonar four pin connector at                Sonar
                    the end of Universal Sonar Extension Cable. The
                    connector is black with a stainless steel threaded
                    locking collar.                                                    Coil Cord


                       NOTICE: Your fish finder should be turned
                       off until this procedure is complete.







                                                                    Mount
                 Four Pin
                Connector                      Universal Sonar
                                                 Cable from
                                                Control Head         NOTICE: If the cable length does not reach the desired
                                                                     fish finder installation location, a 14.5’ extension cable is
                                                                     available (MKR-US2-11) (sold separately).























       18  |  minnkotamotors.com                                                         ©2018 Johnson Outdoors Marine Electronics, Inc.
   13   14   15   16   17   18   19   20   21   22   23