Page 70 - Regal ideas Binder_USA_v3

glass glass
® Frameless Glass Railing glass
Stair Installation Instructions
FRAMELESS GLASS RAILING SYSTEM

Installing Stair Mounting brackets
(CRHS) Glass 1”-1.5” glass
in from tread nosing

1. Decide the layout of the stair glass panels to 1 1” Above 35° 1
determine the treads on which to place the mounting tread nose
brackets. Brackets must be installed on the treads
closest to each end of glass panel.
7/8” 35°
2. To ensure proper alignment of all components when
installing support posts and ADA, position the CRHS
stair mounting brackets so that the line of the stair Diagram I
About ADA armrest in glass railing test
glass intersects with deck glass as described in point
#6 of the Planning Layout section. About ADA armrest in glass railing test

3. Drill the 4 mounting holes for 3/8” bolts and 1/2” hole
for LED wiring. Sweep or vacuum all dust and files
immediately after drilling is complete to avoid scratch- End glass panel 5/8”
ing components while installing. must extend exactly
5/8” past inside edge
4. Position mounting bracket in place while feeding the of stair glass for top
LED wire through the stair tread, taking care that wire and bottom support
post to align.
is not pinched when mount is in place.

Diagram J
4
3/8”
3

3 1/2” 5

5. Make sure the mounting bracket is facing in the
correct direction so that the adjustment plate is
following the same angle as the stairs. 6 6

6. Insert 4 mounting bolts and position mounting plate
(MP5) onto bolts underneath the stair tread. 7

7. Tighten nuts onto bolts to secure. Make sure LED
wire is through center mounting plate hole before 6 6
tightening.
8. Connect LED bulb leads to the connector cord.

9. Use UV stabilized cable ties to secure wiring if using
metal stair stringers. Use 1/4” cable clips for wood
stringers.
Note: Make sure to install base covers on all
mounting bracket before installing glass.

14
regalideas.com Section 3 | Installation on Stairs
V1.2