Page 95 - Regal ideas Binder_USA_v3

urbanrail ® Installation Instructions

Gate Installation (Continued)

Close gate latch pin into gate Use USC50 screws to fasten Use USC50 screws to fasten Urban rail gate is now
latch and mark position of front of gate latch into post. side of gate latch into post. completed
gate latch onto post.
TIP: Pre-drill using 1/8”
(3mm) drill bit.

Tempered Glass Installation (CTG)

Components you will need: Measure your top and Cut your glass gaskets Fit in your Glass Vinyl Insert
bottom rail openings (URGG) to fit inside the top (URGG) into the bottom rail.
• Glass Vinyl Insert (URGG) (between posts). rail and inside the bottom
• Regal ideas Tempered rail.
Glass Panels (CTG)
• Leg Support (URLS)

1

2

Drainage holes. Install glass by (1) first Use bottom rail support legs
sliding the glass up into the in the center of all glass rail
Drill 3/16” diameter weep top vinyl insert and then (2) sections.
Fit in your Glass Vinyl insert holes through vinyl insert and down into the bottom vinyl (See Instructions Page 2)
(URGG) into your top rail. bottom rail every 16″ – 24” insert.
to allow any water/moisture
to escape during the various
seasons.

regalideas.com/urbanrail | Toll Free: 1-800-819-4344 | Fax: 1-604-952-4291 | email: sales@regalideas.com 11

V2