Page 371 - 2018_IRC

WALL CONSTRUCTION

TABLE R608.9(12)
COLD-FORMED STEEL ROOF TO TOP OF CONCRETE WALL, FRAMING PARALLEL a, b, c, d, e
BASIC WIND SPEED (mph) AND WIND EXPOSURE CATEGORY
ANCHOR BOLT SPACING TENSION TIE SPACING 115B 120B 130B 140B 150B 160B
(inches) (inches) — — 110C 119C 127C 136C
— — — 110D 117D 125D
12 12 6
12 24 6
16 16 6 6
16 32 6 6
19.2 19.2 6 6
19.2 38.4 6 6 6
24 24 6 6 6B

For SI: 1 inch = 25.4 mm, 1 mile per hour = 0.447 m/s.
a. This table is for use with the detail in Figure R608.9(12). Use of this detail is permitted where a cell is not shaded.
b. Wall design per other provisions of Section R608 is required.
c. For wind design, minimum 4-inch-nominal wall is permitted in cells that do not contain a number.
d. Number 6 indicates minimum permitted nominal wall thickness in inches necessary to develop required strength (capacity) of connection. As a minimum, this
nominal thickness shall occur in the portion of the wall indicated by the cross hatching in Figure R608.9(12). For the remainder of the wall, see Note b.
5
e. Letter “B” indicates that a / -inch-diameter anchor bolt is required.
8

346 2018 INTERNATIONAL RESIDENTIAL CODE ®
Copyrighted © 2017 by, or licensed to, ICC (ALL RIGHTS RESERVED); licensed to UL, LLC pursuant to License Agreement with ICC. No further reproductions authorized or distribution authorized.
ANY UNAUTHROIZED REPRODUCTION OR DISTRIBUTION IS A VIOLATION OF THE FEDERAL COPYRIGHT ACT AND THE LICENSE AGREEMENT; AND SUBJECT TO CIVIL AND CRIMINAL PENALTIES THEREUNDER.