Page 43 - QR CIMAR LASER SCREED

CLEAN UP PROCEDURES
Even though the concrete is in and the floor is within tolerances, your day isn’t done until you
completely clean your screed.
1. Before you move to the washing area, switch the laser control over to the manual mode and drive
both actuators to the top of their travel.
2. Then engage the Side Lock Switch. Finally, lower the receiver masts, disconnect the laser receivers,
remove them from the masts, and coil their connecting cords.
3. Now you can drive to where the machine will be washed.
4. Once you’re in position, turn off the machine and shut off the fuel supply to the engine.
5. Keeping water away from the electronic equipment, wash the entire screed with a pressure washer
capable of providing 3000psi. When you do this, be very careful because a tight high pressure stream
of water is sometimes powerful enough to remove paint, safety decals, and even damage the tires.
NOTE: Do not tip the machine all the way back to the frame to wash under the vibrator plate. The air
filter ban become filled with oil and cause machine performance problems. Remove the head assembly
from the lift arm to clean the bottom of the vibrator plate.

41