Page 14 - QR CIMAR MULTI-GRINDER

CMG/TEESIN/MAN/01/15 Compile by CJ

The Rule of Thumb:

 If the disc begins to grind super well, STOP! It is an indication that the diamond
tooling is wearing too fast. Inspects the tooling regularly for unusually high
diamond exposure. This can be detected by running the finger over the surface the
diamond grit is sticking out a lot. The diamond grit will be falling out of the
matrix before you have had a chance to wear them out.

 Use diamond tooling with a HARD BOND and/or more segments.
 Be certain to use the machine weights to reduce the weight of the machine on the

tooling.
 In addition, a vacuum that will extract as much dust away as quickly as possible

will greatly improve the life of the tooling. If there is a lot of dust rolling between
the floor and segments it will cause excessive wear.

5.3) Diamond Size

The larger diamond grit (low number) for faster removal of concrete and for harder
concrete.

5.4) Polished concrete

To polish concrete start with a coarse diamond and approximately double the grit number
(halve the diamond size) with each new pass until the floor is polished.

For technical questions, please call +65 - 66431213 12
For Products Enquiry, please call +65 - 67581211