Page 21 - 360 Steamer.Manual.ENG

HOW TO DESCALE THE BOILER / INTRODUCTION
You must descale the boiler when the probe symbol appears on the display with the word “CLEAN”. The
hardness of the water varies significantly depending on your location and will affect how often and when
you need to descale the boiler. The harder your water, the more often and sooner you need to descale
the boiler. Descale the boiler if you notice a significant drop in steam emission or if the unit begins eject-
ing particles of lime scale in the steam.

! CAUTION! MAKE SURE THE APPLIANCE HAS COOLED DOWN COMPLETELY
! WARNING! MAKE SURE TO UNPLUG THE UNIT BEFORE BEGINNING THE DESCALING PROCESS.

1.PREPARATION
Locate the boiler drain cap (P) on the bottom of the unit (wrench CH20).

Place a bucket under the drain cap. Open the drain cap by turning it counter-
clockwise.

Drain the boiler completely. Screw the drain cap back on. Hand tighten only. Q

Repeat the same procedure to empty the refilling tank by unscrewing plastic cap Q.
P
2.DESCALING
A) Remove the cap (M) of the water tank and pour in a bottle of Carico Descaling
Solution and about 0.25 gal of tap water.
B) Plug in the unit and press button (A) on the display. The pump will work for
about 50 seconds. You will hear an acoustic signal, and the water tap symbol (F)
will flash on the display.
C) Press the (A) key several times until the resistor symbol (I) starts flashing. Unplug the unit.
D) Wait 15 minutes for the descaling solution to go work.
E) Replace the bucket under the appliance and open the drain cap (M).
F) Empty the boiler.
G) Screw the draining cap back on, tighten using the CH20 wrench.
H) Repeat the same procedure for the water refilling tank cap (Q).

3.RINSING N M
A) Completely fill the water tank (M) with tap water.
B) Gently move the unit from side to side to remove any loose limescale residue.
C) Plug in the unit and press the (A) key on the control panel. The pump will work for about 50 seconds.
You will hear an acoustic signal, and at the same time, the water tap symbol (F) will flash on the display.
Press the (A) key several times until the resistor symbol (I) starts flashing.
D) Unplug the unit.
E) Empty the water from the boiler as noted above using the draining cap (P). Hand tighten only.
F) Completely fill the refilling tank (M), following the indications in Chapter 3 “Filling the water and/or
detergent tank”.
G) The appliance is now ready for use again.

21