Page 39 - DRAGO GT Operators Manual
P. 39
Section 5 – Operation
5.7 – Automatic Header Height Control
Automatic header height control is optional on all
Drago GT corn heads. This option allows the height of
the corn head to be automatically controlled. A total of
one to five height sensors can be installed depending
on the width of the corn head. The height sensor (A)
is installed under the gathering point. For more
information refer to the Headsight Operators Manual.
Important: For best performance, mount
the height sensor as far forward in the slots
in the mounting plates as possible.
Wire Routing:
The wire harnesses for the automatic header height
control should be inspected periodically to ensure that
they are installed in such a way to avoid crop material
and other foreign objects. Most causes regarding the
failure of this system can be traced back to poorly
routed or secured wires. View the Headsight
Installation Instructions available at
www.headsight.com.
Calibration:
Prior to operation it is critical to perform a successful
calibration. Failure to perform a successful calibration
will cause poor performance and may cause snouts to
become damaged. Visit Headsight at
www.headsight.com to view the calibration procedure
for the model of combine being used.
Page | 37
