Page 383 - Workshop Manual - Aumark (BJ1051)

04-239
Diagnosis-Wipers and washers
Diagnostic Procedure

1. Checking fuse
(a) Ignition switch: OFF.
(b) Check fuse F20 (15A) in body fuse
block.

04

Is check result normal?
Yes > Go to step 2.
No > Replace fuse.
2. Checking wiper motor

(a) Checking function in LO
• Connect battery positive (+) to
connector pin 2 and negative (-) to
connector pin 3, and check if the
motor runs in LO.
(b) Checking function in HI
• Connect battery positive (+) to
connector pin 1 and negative (-) to
connector pin 3, and check if the
motor runs in HI.
(c) Checking auto stop function
• Connect battery positive (+) to
connector pin 2 and negative (-) to
connector pin 3, and disconnect pin
2 when the motor is running in LO
unless it is at any position for auto
stop.

Page 383