Page 395 - Workshop Manual - Aumark (BJ1051)

04-251
Diagnosis-Wipers and washers

Wiper can not return to original position after switched off

Circuit Diagram

ignition switch
White-blue black - white

IG 04
power car body fuse box
relay
blue blue blue blue

white three-in-one
controller
blue three-in-one controller

white- blue- blue-green-
red yellow black
teminal
switch blue-
(position) blue
Chasiss fuse block 1 white- cubicle red
black switch
intermittent
Low shaft
High shaft
blue-orange
white
blue-black

battery
white-black
wiper-motor

white-black

Diagnostic Procedure
1. Checking harnesses
(a) Use a multimeter to measure resistance of harness between pin 14 of three-in-one controller
and pin 5 of wiper motor.
(b) Use a multimeter to measure resistance of harness between fuse F20 and pin 6 of wiper
motor.
Resistance: ≤2Ω
Are check results normal?
Yes > Go to step 2.
No > Replace harnesses.

Page 395