Page 396 - Workshop Manual - Aumark (BJ1051)
P. 396
04-252
Diagnosis-Wipers and washers
2. Checking wiper motor
(a) Remove wiper motor (refer to “Chapter 55 Wipers and Washers-Wiper Motor Assembly,
Replacement”).
(b) Checking auto stop function
• Connect battery positive (+) to
connector pin 2 and negative (-) to
connector pin 3, and disconnect pin 2
when the motor is running in LO unless
it is at any position for auto stop.
04
• Restart the motor by connecting pins 2
and 5 of the motor and connecting
battery positive (+) and pin 6, and run it
in LO.
• Check if auto stop position is correct.
Is check result normal?
Yes > Replace three-in-one controller.
No > Replace wiper motor assembly.
Page 396
