Page 401 - Workshop Manual - Aumark (BJ1051)

04-257
Diagnosis-Audio System

Audio System

Notes

1. It is strictly forbidden to refit this audio system or add other audio equipment to it.
2. This audio system uses the following radio bands.
FM
Radio wave AM
Method of
modulation Amplitude modulation Frequency modulation
Wave band AM1 AM2 FM1 FM2 FM3 04

Frequency range 522~1620 KHz 87.5~108 MHz
3. Notes for CD player
Notices:
Do not view the laser head directly because the CD player uses invisible laser beams. Be sure
to follow instructions to operate the player.
(a) A CD player uses a laser head to read digital signals recorded on CDs. It plays music and
other items by converting digital signals into analog signals.
(b) The CD player can only play the CDs
with this identification (ID).

(c) Notes for use of CDs
• This CD player is of single-disc type. Never put multiple CDs in it at the same time,
otherwise it will be damaged.
• This CD player uses 120±0.03 mm CDs.
• Failure to play CDs may result due to characteristics of CDs or damage, dirt or aging,
etc. caused by extended placement in the vehicle.
• Keep CDs free from dirt. Take care not to damage CDs or leave your finger marks on
them.
• Keep labeled surface of a CD up, and take it by gripping its outer edge and center hole.
• Exposing part of a CD out of slot long after the disc eject button is depressed may cause
CD deformation and render it disabled.
• If adhesive tape, sticker, or paste marks of any similar labels are left on a CD, the CD
will not be ejected or CD player breakdown will result.
• Avoid exposing CDs to direct sunlight. (Exposure to direct sunlight may result in CD
deformation which will render CDs disabled.)
• Do not use CDs of odd shapes, otherwise CD player breakdown may result.

Page 401