Page 6 - COVID Assessment Centre TRAINING DOCUMENT

Steps for Putting on and Taking off Personal Protective Equipment (PPE)

Putting On PPE

Put on PPE outside of the patient room

1. Perform hand hygiene
2. Put on gown
• Tie neck and waist ties securely

3. Put on surgical mask/fit tested N95 respirator
• Place mask over nose and under chin
• Secure ties, loops or straps
• Mould metal piece to your nose bridge
• Perform a seal-check
4. Put on eye protection
• Put on eye protection and adjust fit
• Face shield must fit over brow and over the N95 respirator (if
applicable)
5. Put on gloves
• Put on gloves, taking care not to tear or puncture gloves
• The gloves should fit over the cuff of the gown

Taking off PPE

Complete Steps 1 through 5 within the patient room and steps 6 through 8 outside
of the patient room or in the ante-room.

1. Remove gloves:
• Grasp the 1st glove by pinching the inner wrist area below the cuff
• Pull halfway down creating a cuff over the entire thumb
• Using the clean area, grasp the 2nd glove and remove completely
• Using the clean hand remove the remaining glove by pulling from the
cuff area

2. Perform hand hygiene

3. Untie waist tie

4. Remove gown:
• Remove gown in a manner that prevents contamination of clothing or
skin
• Undo the neck ties, pull the outer contaminated side of the gown
forward and turn inward, roll the gown off the arms and into a bundle
• Discard immediately in a manner that prevents air disturbance

5. Perform hand hygiene

6. Exit patient environment

7. Remove eye protection
• Remove by pulling ties straight up and forward. Discard into waste

8. Remove surgical mask/N95 respirator
• Remove by touching ties, ear loops or straps only
• Grasp straps, pull straight up and forward off the head bending
forward to allow the mask to fall from the face
• Discard immediately into waste

9. Perform hand hygiene

References: SMH & SJHC Routine Practices and Additional Precautions Policies, CDC PPE-Sequence