Page 71 - Hydra-matic 6 Speed RWD Technician's Guide (October 2005)

56

(1)
TORQUE
(53)
INPUT
ASSEMBLY
CONVERTER
SUN GEAR
➤
➤ ➤ ➤ (1) CONVERTER TORQUE POWER FROM 1
➤ to roll. disengaged, the output shaft is free to rotate allowing the vehicle lugs on the output shaft assembly (70). With the park pawl park pawl spring (501) releases the park pawl (502) from the that the park lock actuator assembly (503) is disengaged. The mechanical power flow is identical to Park (P) range, except When the gear selector lever is placed in the Neutral (N) position, * Applied with no load ASSEMBLY DIFFERENTIAL APPLIED* TO CLUTCH TERMINATED REVERSE POWERFLOW LOW A
(2)
TORQUE
HOUSING
ASSEMBLY
CONVERTER
➤
(WITH FLUID PUMP)
(56)
4-5-6
SHAFT)
CLUTCH
ASSEMBLY
(w/TURBINE

Figure 51

(51)
ASSEMBLY
1-2-3-4 AND 3-5
REVERSE CLUTCH
CLUTCH
REVERSE
APPLIED*
LOW AND

(70)
SHAFT
OUTPUT
ASSEMBLY
(503)
PARK
PAWL
ACTUATOR
ASSEMBLY
(52)
(502)
PARK
PAWL
INPUT
NO POWER
CARRIER
ASSEMBLY
TRANSMITTED
DISENGAGED
* APPLIED BUT CARRYING NO LOAD

•
1
2
3

CLUTCH

3-5 REV.
CLUTCH
in the Neutral position.
4-5-6
CLUTCH
by the converter turbine.
Powerflow Terminated
and powerflow is terminated.
2-6
CLUTCH
Power from Torque Converter
NEUTRAL
the vehicle is standing still or moving.
CLUTCH
APPLIED*
LOW & REV.
LOW
SPRAG
CLUTCH
need to be applied as another component releases.
Low and Reverse Clutch Applied/Preparation for a Shift
Without any clutches applied, or sprag clutches holding, the
shift timing as only one clutch will need to be applied to
The turbine shaft with 4-5-6 clutch assembly (56) is driven
preparation for a shift into either 1st or reverse. This aids
The low and reverse clutch is applied in Neutral in
turbine shaft with 4-5-6 clutch assembly (56) rotates freely
Neutral range may be selected for starting the engine when
The manual shift shaft (508) and the manual valve (354) are
range, the design includes that only one component will
range 1st without engine braking. Also, in each forward
achieve either range. The 6 Speed RWD is designed to have
two components applied for each gear range, except drive
56A