Page 137 - Icon Ridge Presents ORION

Thread tools \ Technical introduction – thread milling

Internal cooling during thread milling

Internal cooling is of particular importance when it comes to thread milling. The short chips must be rinsed
out of the working area by the coolant medium. Otherwise, the chips produced could damage the surface of
the thread or even cause cavities on the tool.

We make a fundamental distinction between thread milling cutters with axial coolant fl ow, used for blind Thread milling cutters with axial coolant flow
holes, and modifi ed variants with radial coolant fl ow, which are ideal for through holes.

Thread milling cutters with radial coolant flow
Clamping device recommendation for thread milling

Collet chucks Shrink-fit chucks Hydro-expansion Surface chuck Power chucks

chucks

Suitable for pitches up to 1.5 mm
Suitable for pitches above 1.5 mm

Vibration-damping
Surface quality

= very well suited = suitable = limited suitability

Source: Hahn+Kolb Werkzeuge GmbH
Technical data subject to change. www.iconridge.com
Availability subject to country specific rules and regulations. 137

0274_EN_2018_KERN[21847329]-m.indd 274 12/17/2018 3:32:10 PM