Page 1179 - 2006 HARLEY FLSTCI SERVICE MANUAL
P. 1179

2.4











                            NOTE To service tire or valve stem, see TIRES in the Softail Models See Figure 2-3. Label all components as they are disas- semble so they may installed in their original locations. On left side, remove brake disc fasteners (4) and brake If required, service wheel bearings in the following order: Remove wheel bearing (6) on left side of wheel (8)  Remove wheel bearing (11) on right side of wheel  NOTE The left to right procedures maintains the correct dimensions for installation. The procedures for bearing replacement are the same as SEALED  WHEEL BEARINGS in the Softail  Inspect all parts for wear or damage.  1WARNING 1WARNING Always r


                      DISASSEMBLY  Service Manual.  1.  2.  disc (5).  3.  a.   hub.  Remove spacer (12).  b.   c.   (8) hub.  Models Service Manual.   4.  ous injury. (00111a).  5.












                                      Rotate wheel several times to check for rough or uneven
                           Block motorcycle underneath frame so weight of motor-
                                  disc thickness. See BRAKE PADS AND DISCS in the
                                        bearing rotation. See SEALED WHEEL BEARINGS in
                                               WHEEL BEARINGS in the Inspect wheel bearing end play and service bearings if Remove long and short caliper mounting bolts. Slide Support caliper and brake lines with a rubber bungee  Loosen right fork slider cap nuts and pull axle (14) free. Label wheel spacers for location (left or right) and orien-
                               Inspect brake disc and pads for wear. Measure brake






              FRONT WHEEL    cycle is off front wheel.  Softail Models Service Manual.  the Softail Service Manual.  necessary. See SEALED  Softail Service Manual.  brake caliper off of brake disc.  cord. Be careful not to scratch fender or frame finish.  NOTE Do not operate the front brake lever with the front wheel removed or a caliper piston may be forced out of its piston bore. Reseating a piston requires disassembly of the caliper. See Figure 2-3. Remove front axle covers (10).  Remove axle nut (1), lockwasher (2) and washer (3).  tation (fork side or wheel side). Remove wheel assembly from forks.  2006 FLSTFSE 2 : Chassis










          HOME        REMOVAL  1.  2.  3.    4.     5.   6.             7.  8.  9.  10.  11.                                                             2-4
   1174   1175   1176   1177   1178   1179   1180   1181   1182   1183   1184