Page 239 - 2006 HARLEY FLSTCI SERVICE MANUAL

“no rsp” displayed. See applicable code from other modules. Models not equipped with a tachometer will display “no rsp” normally. If “no rsp” displayed on odom- eter on tachometer equipped vehicle, see 2.4 SPEEDOME- TER. NO “end” displayed. To clear all DTCs for selected module hold reset switch for more than 5 sec- onds. If DTCs are not to be cleared, Press and release reset switch. Part number of module will be displayed.

NO

DTC displayed. Press and release reset switch. Are more DTCs displayed? YES

2

NO See 2.2 INITIAL DIAGNOSTIC CHECK: SPEEDOMETER. Device response? YES “none” displayed. Press and release reset switch. Part num- ber of module will be displayed. Figure 5-9. Speedometer Self Diagnostics

Speedometer Self Diagnostics (chart)
To display DTCs for the ECM, press and hold reset switch for more than 5 seconds. To display DTCs for TSM/TSSM, press and hold reset switch for more than 5 seconds. To display DTCs for speedometer, press and hold reset switch for more than 5 seconds. To display DTCs for tachometer, press and hold reset switch for more than 5 seconds.

1 Press and release reset switch again to continue to next module.
While holding odometer reset switch in, turn ignition switch to IGN. Make sure Run/Stop switch is in RUN position. Release reset switch. Does “diag” appear? YES Press and release reset switch. “PSSPT” appears. ”P” flashing. To choose TSM/ TSSM, press and release reset switch. ”S” flashing. To choose Speedometer, press and release reset switch. ”SP” flashing. To choose Tachometer, press and release reset switch. ”T” flashing. To choose ECM, press and release reset switch. 2006 Softail: Engine Management (EFI)

HOME 5-20