Page 244 - 2006 HARLEY FLSTCI SERVICE MANUAL
P. 244

5.10                                                                                                                                       5-25







                                                     Figure 5-15. Spark Tester                     Figure 5-16. Ignition Coil Circuit Test Check TP sensor value with digital volt/ohmmeter (DVOM). If TP sensor is equal to or greater than 3.8 volts, system is in “clear flood” mode and engine will not start. While spark is present, fuel is shut off. Problem can be mechanical, such as  2006 Softail: Engine Management (EFI)








             ENGINE CRANKS, BUT WILL NOT START




                      d0273x8x                                7863                                     Diagnostic Tips  throttle cables stuck.




                                                                  HD Electrical System Analyzer) or load test. Replace the
                                                                    battery if necessary. See BATTERY in the Softail Service
                                                             and recharge if below 12.60V. Check battery connections
                                                               and perform either a conductance test (using MCR-101
                                                                        Connect BREAKOUT BOX (Part No. HD-43876). See 5.7
                                                                                         While cranking engine, look for spark. Repeat pro-
                                                                                                   TESTER (Part No. HD- Engine will not spark with both spark plugs removed. When Use HARNESS CONNECTOR TEST KIT (Part No. HD- Typically, when IAC is not functioning, the engine will not start unless throttle is opened and the engine will stall See Figure 5-16. Plug IGNITION COIL CIRCUIT TEST ADAPTER (Part No. HD-44687) and FUEL INJECTOR TEST LAMP (Part No. HD-34730-2C) into Breakout Box Terminals 13 and 11. Start engine. If lamp flashes, no problem is found. Repeat for Breakout Box Terminals 13 Use HARNESS CONNECTOR TEST KIT (Part
                                                                                  b. See Figure 5-15. Attach cable to SPARK TESTER
                                                                                     (Part No. HD-26792). Clip tester to cylinder head
                                             The reference numbers below correlate with the circled num-
                                                  Check for diagnostic trouble codes (DTCs). See
                          If the starter will not crank the engine, the problem is not EFI
                            related. Refer to SECTION 1-STARTING & CHARGING or
                                                      5.4 CHECKING FOR DIAGNOSTIC TROUBLE CODES:
                                                           Check the condition of the battery. Perform a voltage test
                                                    RETRIEVING DIAGNOSTIC  TROUBLE CODES under
                                                                                              NOTE



                     GENERAL  SECTION 3-TSM & TSSM.  DIAGNOSTICS  Diagnostic Notes  bers on the Test 5.10 flow charts.  EFI.   Manual.  BREAKOUT BOX: EFI. Remove spark plug cable from spark plug. Visually check condition of plug.   bolt.   cedure on other spark plug cables.  checking for spark, use SPARK  26792) with both plugs installed.  41404), gray pin probe and patch cord.   when throttle is closed.  and 29. 41404), brown socket probe and patch cord.



         HOME                                     1.       2.           3.   4.  a.      c.             5.   6.    7.            8.
   239   240   241   242   243   244   245   246   247   248   249