Page 760 - 2006 HARLEY FLSTCI SERVICE MANUAL

SPECIALTY TOOL If pivot shafts (19) were removed, Tighten to 10-20 ft-lbs (13.6-27.1 TOOL (Part No. HD-39754) 2-111 2006 Softail: Chassis

Fender link tool apply LOCTITE THREADLOCKER 262 (red) to threads Be sure rubber spacer (18) and washer (17) are in place. Install pivot links (15) on pivot shafts. between the pivot links (15) and tighten snugly. The tool will properly spread and hold the links in position while Very carefully position fender (1) between forks and pivot Be sure fender inserts (13) are in fender. Install shoulder screws (16) and locknuts (12). Remove fender link assembly tool. Tighten shoulder screws to 10-20 ft-lbs Be sure rubber spacer (5) and washer (6) are in place. Place washer (8) between fender bushing and brake reaction link (9). Install screw (11) and s

PART NO. HD-39754 Figure 2-135. See 1. before installation. Nm). 2. Place FENDER LINK 3. you install the fender. 4. links (15). 5. (13.6-27.1 Nm). 6. 7. Install new cotter pin (2).

11WARNING 1WARNING Do not use aftermarket parts and custom made front forks which can adversely affect performance and han- dling. Removing or altering factory installed parts can adversely affect performance and could result in death or Alter the fender brackets to lower the fender. Doing this could allow the front wheel to bind on the fender during hard stops or big bumps. Replace the O.E.M. tire with a higher-aspect ratio tire. Doing this could allow the front wheel to bind on the fender during hard stops or big bumps. Replace the O.E.M. tire on FXSTS model with a tradi- tional-looking 16 in. front wheel, tire and front fender. In addition

INSTALLATION serious injury. (00001a)

HOME DO NOT: ● ● ●