Page 764 - 2006 HARLEY FLSTCI SERVICE MANUAL

2-115 2006 Softail: Chassis

Connect negative battery cable. 11WARNING 1WARNING After installing seat, pull upward on front of seat to be sure it is in locked position. While riding, a loose seat can shift causing loss of control, which could result in death or serious injury. (00070a) 11WARNING 1WARNING Be sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury. (00316a) Check turn signal and lamp operation.

6. Install seat. 7. 8. Figure 2-139. FXST, FXSTS, FXSTB Rear Fender Wire Routing

NOTE In next step, be sure wire harness is routed so tire will not Route turn signal wires through holes in fender. Install See Figure 2-138. Carefully place the fender into posi- tion. Install fender supports using hardware shown. Tighten to 21-27 ft-lbs (28.5-36.6 Nm). Connect the turn signal wiring harness at connector [7] under the seat. Also attach wiring for left and right turn

INSTALLATION wires inside connector terminals. signals. Install ignition control module. Install saddlebags if equipped.

HOME contact wiring. 1. 2. 3. 4. 5. 11985